Self canceling turn signals

**bolus** · February 23, 2011, 06:48 PM

Here is our flasher

**Steve** · March 7, 2011, 03:44 PM

Looks like this module supports LEDs. It's more expensive, but is it more expensive than the SDC unit plus the LED regulators? It also eliminates a bunch of splices.

EDIT: Just found a link to the SDC one that says it ALSO supports LEDs. So it looks like the SDC is the way to go. Ordering one now.

**Terry Kennedy** · March 7, 2011, 03:49 PM

Originally Posted by bolus

Here is our flasher

The "Bulb Failure Indication" is a guarantee that it will flash too quickly with resistor-less LEDs.

**Steve** · March 7, 2011, 03:56 PM

But would the SDC unit allow us to bypass the flasher altogether? Their wiring diagram leads me to believe so.

**Steve** · March 7, 2011, 04:00 PM

I just bought this one on eBay for $66.49 including shipping (slightly cheaper than SDC direct or Amazon).

There's one left on that auction if anyone else wants it.

**bolus** · March 7, 2011, 04:00 PM

see my wiring diagram. You bypass the flasher since it is solid state in the SDC unit. I dont know if it picks up a burnt out bulb though. will try tonight

**Steve** · March 7, 2011, 04:05 PM

Cool - then I'm optimistic that the LED bulbs will flash at the appropriate rate. However, I'm doubtful that the system will indicate a burnt out bulb. But the good news is that the LEDs take a LONG time to burn out.

Would love to see some video of the flashing bulbs when you get them in, Bolus!