Results 1 to 3 of 3

Thread: Throttle by Wire

  1. #1
    Up Quark flying phil's Avatar
    Join Date
    Mar 2011
    Location
    Scottsdale, Arizona
    Posts
    19
    Country
    United States

    Throttle by Wire

    Had an interesting one today. Idled car for five minutes to warm up, held throttle for one minute at approx. 2500 RPM, let off throttle slightly... car went to idle despite flooring pedal. Engine only responsive after fully releasing throttle. Anyone else...?

  2. #2
    Neutrino
    Join Date
    Sep 2010
    Location
    Dallas Texas...YEE-HAW
    Posts
    1,213
    Country
    United States

    Re: Throttle by Wire

    is yours a honda or ecotec

    brammo forgot to install the retainer clip on several ecotecs causing the wire harness to come loose from the throttle body, therefore any input on the throttle pedal did nothing, car would start and idle perfect.

    even if you have a honda, it's something between the pedal and the throttle body so you should look for loose connections on those two parts first.

    It happened to me on the highway WHILE my go pro was running lol caught it on video

    [youtube:2mnk64dk]http://www.youtube.com/watch?v=cuWf5RtFyOk[/youtube:2mnk64dk]

  3. #3
    Proton Terry Kennedy's Avatar
    Join Date
    Aug 2010
    Location
    NYC
    Posts
    796
    Country
    United States

    Re: Throttle by Wire

    Quote Originally Posted by silver
    even if you have a honda, it's something between the pedal and the throttle body so you should look for loose connections on those two parts first.
    Regardless of engine type, if it is a drive-by-wire (electric) gas pedal and you have a check engine light installed but not illuminated, or see no fault codes, this sort of fault will always be on the output side (throttle body, wiring harness, etc.) of the ECU/PCM/whatever. If it is on the input side, there are a large number of safety interlocks which cause the engine to go into low-power or limp mode*. That's to prevent a wiring problem or bad sensor in the accelerator pedal commanding the ECU to "floor it".

    Since the ECU doesn't have any direct way to tell if the throttle body activated, all it could do is correlate what it thinks it is asking for with readings from some other sensor, like engine RPM. AFAIK, the Ecotec doesn't do that. Not sure about the Honda.

    * Because GM Racing didn't do the full set of tests that a production-vehicle ECU goes through, all of the things that would normally set "reduced power (limp) mode" on a production Ecotec will cause the Brammo ECU to stay at idle and ignore any command inputs (like the accelerator).
    An Atom Across America blog - http://www.atomacrossamerica.org Brammo Atom 300 Ecotec - 08/2006 build
    Note - if any image I included or link I posted is broken, change "tmk.com "to "glaver.org" in the URL to fix it.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •